Product Name：2L Series Direct-acting and Normally Closed Flow Control Valve
Product Model：2LH030 2L030 2LH050 2L050
Brand：AirTAC

Type/Item:		Port Size:	Orifice Size(Φmm):	Cv	Valid Area or Section(mm²)	Weight（g）:	Max Operating Pressure Differentia:		Proof Pressure:
							MPa	psi	MPa	psi
2LH030	-06	PT1/8	2.0	0.18	3.0	300	2.0	300	3.0	450
	-08	PT1/4				290
2L030	-06	PT1/8	3.0	0.33	6.0	300	1.0	150
	-08	PT1/4				290
2LH050	-10	PT3/8	4.0	0.55	10.0	600	2.0	300
	-15	PT1/2				590
2L050	-10	PT3/8	5.0	0.83	15.0	600	1.0	150
	-15	PT1/2				590

① PT thread, NPT thread and G thread are available.
②The weight in the table is the terminal valve's weight, 2W030 series gormmet valve's weight is 10g less than terminal's. 2W050 series gormmet valve's weight is 20g less than terminal's.

Specification of coil:

Valve Type:	Coil Type:	Power Type:	Frequency(Hz)	Voltage Range	Eletrical Entry	Power Consumption（VA/W）	Insulation	Temperature Rise(℃)
2L□030	CDA116 CLA116	AC	50	±15%	Terminal(CAD) Gormmet(CLA)	10.0VA	Class B	35
			60			8.0VA		30
		DC	-	±10%		6.5W		30
2L□050	CDA170 CLA170	AC	50	±15%		25.0VA		60
			60			22.0VA		55
		DC	-	±10%		10.5W		40

Valve's Specification:

Acting:	Direct Acting
Initial Stats:	Normally Closed
Adaptable Fluid:	Steam, Hight Temperature Water, Oil
Viscosity Limit:	Under 20CST
Ambient and Fluid Temperature(℃):		Water	Steam	Oil	Ambient
	Max	150	183	150	100
	Min	1	-	-10	-20

1.Indirect acting(Internal pilot) and normally closed type 2/2 way solenoid valve. Its can change direction quickly and has large flow.

2.It is compact, small and light weight. It is easy to install and dismantle;

3.The valve body is made of brass . The coil has a Heat resistance classification of Class B. The standard seal material is FPM-F. Please contact us if other material are required.

4.The protection class of the coil is IP65 and there is a choice for grommet or terminal electrical entry.

Installation & Usage:

1.Check whether the components have been damaged during transportation before installing and using.

2.Pay attention to whether the flow direction of air (notice “→” direction) and thread type are correct.

3.Please notice whether installation condition accords with technical requirements (such as “working  pressure” and “applied temperature range”);

4.Take measure to avoid vibration and frozen.

5.Before using the fittings and tubes make sure they are clean. When connecting tofittings, be sure the PTFE Thread Seal Tape is used correctly.

6.Keep the dust away. The dust cover shall be installed in intake and outlet when the device is dismantled and stored.